C-Bus 5200PG Especificaciones descargar pdf (Pagina 10)

Wiser Home Controller Installation Instructions

2.2 Adding the Wiser Home Controller and CNI

The installer has several choices when adding the Wiser Home Controller to

the customer's network. The basic options are:

• Option A. Connect the Wiser Home Controller's WAN port to the output

of the customer's modem/router as shown in Figure 3. In this

configuration, all network traffic passes through the Wiser Home

Controller's wired and wireless LANs.

• Option B. Place the Wiser Home Controller on the existing customer

LAN as shown in Figure 4. This configuration allows you to make

minimal changes to the customer's equipment setup.

• Option C. Connect the Wiser Home Controller to an ADSL modem in

bridge mode. In this configuration, the Wiser Home Controller is the

direct gateway to the customer's ISP.

Option A

Figure 3. Option A, Wiser Home Controller as the connection point for the

customer's LAN

When using Option A, you must re-establish the IP addresses of the

customer's IP connected devices to subnet 2. You might have to configure

static IP addresses. If you are using wireless devices, you must also

configure the wireless LAN on the Wiser Home Controller.

If the Wiser Home Controller does not provide enough physical connections

for IP connected devices, a hub must be added. Clipsal does not provide the

hub.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Sin comentarios

C-Bus 5200PG Especificaciones Pagina 10